Selected Row Header

I have one note for the UI of the part selection of a PCB. When one row is selected the following line pops up:

This is a bit annoying because then everything is shifted by 1 down (and the cursor is suddenly at a different part) as seen below:


Could this message of “x rows selected” placed elsewhere to not shift all the rows down? This could lead to falsely selected part.

Thank you so much. :smiley:

Good point here! I will add this to our development pipeline!


Hi @andreas-eet, we introduced a new action bar above the table. Feedback is appreciated!

1 Like

Hi @Tim-from-AISLER ! :smile:

Works absolutely fine now! Thank you for taking user feedback that serious! Great improvement here :+1: :sunglasses:

1 Like